Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — MEASURING PPC VALVE OUTPUT PRESSURE

SEN00585-00 30 Testing and adjusting Measuring PPC valve output pressure 1 3. Install oil pressure pickup adapter O2 and con- nect the disconnected hose again. a Measuring instruments for PPC valve output pressure 4. Install nipple [1] of hydraulic tester O1 and con- nect oil pressure gauge [2]. k Stop the machine on a level place, lower the work equipment to the ground, and set the parking brake lever and work equip- ment lock lever in the lock position. a Before measuring the PPC valve output pres- sure, check that the control circuit basic pres- sure is normal. a Measure the PPC valve output pressure under the following condition. 5.

Run the engine and set the work equipment lock lever in the free position. q Hydraulic oil temperature: Within operat- ing range 6. Run the engine at high idle and operate the control lever of the circuit to be measured and measure the oil pressure. a Measure the oil pressure with the lever at a stroke end. a When measuring the blade circuit, operate the lever until the blade floats. 1. Open the cover of the main control valve at the right side of the operator cab. 2. Disconnect PPC valve output pressure hose (1). a For the circuits to be measured, see the drawing on the next page. 7. After finishing measurement, remove the mea- suring instrument and reinstall the removed parts.

52 D65EX, PX, WX-15E0 Symbol Part No. Part name O 1 799-101-5002 Hydraulic tester 790-261-1204 Digital type hydraulic tester 2 799-401-3100 Adapter (size 02)