SEN00585-00 30 Testing and adjusting Releasing residual pressure in work equipment cylinder 1 a When disconnecting the piping between the control valve and work equipment cylinder, release the residual pressure in the circuit according to the following procedure. 1. Loosen the hydraulic tank cap gradually to release the residual pressure in the tank. 2. Set the work equipment lock lever in the free position and operate the blade lever and ripper lever forward, backward, to the right, and to the left. a After the levers are operated 2 – 3 times, the residual pressure in the accumulator is fully released. 3. Run the engine at low idle for about 5 seconds, and then stop it. 4.
Repeat above steps 2 and 3 by 2 – 3 times. 56 D65EX, PX, WX-15E0