Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — BLEEDING AIR FROM WORK EQUIPMENT CYLINDER

30 Testing and adjusting SEN00585-00 Measuring internal leakage of work equipment cylinder 1 Bleeding air from work equipment cylinder 1 a Measuring instruments for leakage of work equipment cylinder a If the work equipment cylinder was removed and installed or its piping was disconnected and connected, bleed air from its circuit according to the following procedure. 1. Run the engine at low idle for about 5 minutes. 2. Running the engine at low idle, extend and retract the cylinder to be bled 4 – 5 times. a Move the piston rod to about 100 mm before the stroke end and never relieve the oil. a Measure the internal leakage of work equip- ment cylinder under the following condition.

q Hydraulic oil temperature: 45 – 55°C a Since the blade lift cylinder is equipped with a piston valve, its internal leakage cannot be measured. 3. Running the engine at high idle and carry out the operation in 2. 1. Extend the cylinder to be measured to the stroke end and set the machine in the measur- ing position. 1) Blade tilt cylinder Lower the blade tip to the ground. 2) Ripper lift cylinder Pull out the shank pin and lower the ripper to the end. 4. Running the engine at low idle, move the cylin- der to the stroke end to relieve the oil. 2. Disconnect hose on the cylinder head side and block the hose side with a plug. a Remove the hose cover of the blade tilt cylinder.

k Take care not to disconnect the hose on the bottom side. 3. Run the engine at high idle and apply the relief pressure to the cylinder bottom side. q Blade tilt cylinder: Operate to tilt blade to left. q Ripper lift cylinder: Operate to lower rip- per. 4. After 30 seconds, measure leakage in 1 minute. 5. After finishing measurement, return the removed parts. D65EX, PX, WX-15E0 55 Symbol Part No. Part name P Commercial item Measuring cylinder