Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS)

SEN00586-00 30 Testing and adjusting 3. Failure code display mode (3-FAULT CODE DISPLAY MODE) In this mode, the contents of each problem in the machine are displayed by a 6-character failure code on multi-information section (2). When a user or a operator needs to be notified of the failure code of each problem, this mode is applied. a Gear speed display section (1) remains normal. 4. Adjustment mode (4-USER ADJUST MODE) In this mode, the display condition of the moni- tor panel can be adjusted on multi-information section (2). a Gear speed display section (1) remains the normal display. No.

Adjustment item 01 Brightness of LCD 02 Brightness of display a When a serviceman needs to check the failure codes for troubleshooting, “Electric system failure code display mode” and “Mechanical system failure code display mode” is recommended to use for more detailed information. a Method of checking failure code: Turn buzzer cancel switch (4) to the [ U ] position on the screen shown on the above, and all failure codes detected cur- rently are displayed at the interval of about 2 seconds.

(To finish displaying, turn the buzzer cancel switch to the [ t ] position.) a For the failure code, see the attached list or “Troubleshooting, Part 1” after viewing service mode “Mechanical system failure code display mode”. 03 Contrast of display 04 Fan 100% mode 05 No injection cranking mode 1) Brightness of LCD This mode is to adjust brightness of the backup lamp at the liquid crystal gauge section. (See Operation and Maintenance Manual.) 2) Brightness of display This mode is to adjust brightness of the backup lamp at the multi-information sec- tion. (See Operation and Maintenance Manual.) 6 D65EX, PX, WX-15E0