SEN00586-00 30 Testing and adjusting 6. Electric system failure code display mode (6-ELEC. FAULT CODE MODE) In this mode, you can check the electric sys- tem failure codes among the information of the troubles that occurred on the machine. 2) Display in case where no codes are recorded If the failure codes which occurred in the past, and the current active failure codes do not exist, the below display will be shown. 1) Selecting and implementing a mode 1] Select “Electric system failure code display mode” on the mode selection screen. 2] If the mode is selected, code (EE) is displayed on gear speed display sec- tion (1) and the title is displayed on multi-information section (2).
3] Display the failure code display screen by operating buzzer cancel switch (4). q [ U ]: Execute mode 3) Display in case where 1 or more codes are recorded If any failure codes which happened in the past or which are currently active exist, the display will be as shown below. 1] : Record No. (Up to 20) 2] : Failure code (Flash if currently active.) 3] : Number of occurrences up to now 4] : Elapsed time measured by service meter after first occurrence 5] : Elapsed time measured by service meter after last occurrence a The below figure shows an example of the display. a Flashing and lighting of failure code Flashing:Code of the failure which is currently detected. Lighting:
Code of the failure which is not currently detected. 14 D65EX, PX, WX-15E0