Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS)

30 Testing and adjusting SEN00586-00 Adjustment mode table and adjustment procedure k Check items marked with q in the Disassembly and assembly column of the above table must be adjusted after the machine is assembled or any controller is replaced. (For the adjustment pro- cedure, see “Adjustment after replacement of controller“) The numbers marked with a can be displayed in order by setting the information switch in the “>” or “ D65EX, PX, WX-15E0 25 No. Code Adjustment item Related information Disassembly and assembly [1] 0001 INP TEL NO. Phone No.

input mode Figure/Symbol a[2] 0002 S/T S.CODE Steering and transmission controller specifica- tion set Code q a[3] 0004 BODY TYPE Machine specification set Code q a[4] 0005 BRAKE BASE Brake potentiometer zero point adjustment Voltage q a[5] 0007 ENG.FULL CH Engine deceleration-cut mode Speed [6] 0008 INJ o 123456 Common rail reduced cylinder mode Speed, Fuel injection rate a[7] 0009 PITCH SENS.

Pitch angle sensor initial set Voltage q a[8] 0010 FAN 70% MODE Fan 70% speed mode Adjustment data a[9] 0021 KMTRX INST KOMTRAX specification set Symbol q a[10] 1005 FAN 100% MODE Fan 100% speed mode Adjustment data [11] 1012 S/T N-SET Steering control lever neutral set Voltage [12] 1013 S/T L-SET Steering control lever left set Voltage [13] 1014 S/T R-SET Steering control lever right set Voltage [14] 2222 HSS ADJUST HSS lever initial current set Current [15] 9997 HI IDLE SET High idle limit mode Speed [16] 9998 SFT INHIBIT Gear speed limit mode Symbol