SEN00586-00 30 Testing and adjusting [1] 0001 : Phone No. input mode [2] 0002 : Steering and transmission controller spec- ification set q This code inputs or changes a phone number to be displayed simultaneously with when the user code is displayed. q This code is used to initialize the specification codes recognized by the steering and trans- mission controller and the set values of the memory in the controller. q The lower part displays a phone number and symbols. q Available characters: 0 1 2 3 4 5 6 7 8 9 : ; ? q The specification code is displayed on the lower line. q How to use:
1) By operating information switch (5), shift up switch (6), and shift down switch (7), input a phone number and symbols. q Adjustment method: 1) Set buzzer cancel switch (4) in the [ U ] position and check that the alarm buzzer sounds. 2) Check that the displayed specification code has changed from [4*4] to [444]. a If specification code [444] is not displayed, the controller wiring harness or the con- troller unit may be defective. a Even if this code is turned off, the setting is effective. q [>]: Moves cursor rightward. q [ q [UP]: Advance the numeric character or character (in the order of available charac- ters). q [DOWN]: Reverse the numeric character or character.
(in the order of available characters) 2) Set buzzer cancel switch (4) in the [ U ] position and check that the alarm buzzer sounds. a Sixteen digits of numeric characters are provided. To avoid confusion, input sym- bols other than numeric characters at dig- its you will not use. a 0 (zero) is input at all places of the lower part before shipment from our factory. (No phone number is displayed under this con- dition.) a Even if this code is turned off, the setting is effective. [3] 0004 : Machine specification set q This code is used to have the machine specifi- cation recognized by the controllers which compose the system. q The machine specification code is displayed on the lower line.
q Adjustment method: a Since this code is reset when “Steering and transmission controller specification set” is executed, adjust it after that. 1) Select the code of the machine specifica- tion by setting shift up switch (6). 2) Set buzzer cancel switch (4) in the [ U ] position and check that the alarm buzzer sounds. k If the machine specification is different from the setting in the controller, the machine may move abnormally or an error may take place. Accordingly, be sure to match the set- ting to the machine specification. a Even if this code is turned off, the setting is effective. 26 D65EX, PX, WX-15E0