Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS)

30 Testing and adjusting SEN00586-00 While this code is displayed, its function is enabled and the auto-deceleration function is stopped. a If this code is turned off, its function is dis- abled. [4] 0005 : Brake potentiometer zero point adjust- ment [6] 0008 : Common rail reduced cylinder mode a When the engine common rail system seems to be defective, this code is used to stop inject- ing fuel into 1 or more cylinders (reduce the number of effective cylinders) while the engine is running and find out a defective cylinder from the change of the engine speed.

a Since this function diagnoses a failure based on the difference of the engine speed in the reduced cylinder mode operation from that in the normal mode operation, use this function while the engine is running. q This code is used to adjust the zero point of the potentiometer of the brake pedal. q The deviation from the standard is displayed by voltage on the lower line (Display range: –2500 – 2500). q Adjustment method: With the brake pedal released, set buzzer can- cel switch (4) in the [ U ] position and check that the alarm buzzer sounds. a Even if the adjustment is carried out, the display of the lower line does not change. a Even if this code is turned off, the setting is effective.

a This code is not for the adjustment of the braking performance, etc.. q The engine speed and fuel injection rate are displayed on the lower line (Display range: 0 – 3000, 0 – 1000). q How to use: Select the cylinders to be turned off for the reduced cylinder mode operation by operating information switch (5) and buzzer cancel switch (4). Use this method to turn on the selected cylin- ders again, too. q [>]: Moves cursor rightward. q [ q [ U ]: Executes or stops reduced cylinder mode operation. [5] 0007 : Engine deceleration-cut mode q This code is used to stop the auto-deceleration function of the engine and check the high idle speed of the engine unit.

q The engine speed is displayed on the lower line (Display range: 0 – 3000). q How to use: D65EX, PX, WX-15E0 27 No. Specifications 000 Standard 010 Pitch specification