Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS)

SEN00586-00 30 Testing and adjusting a The below figure is an example that No. 2 cylinder is turned off for reduced cylinder mode operation and turned on again (The cylinder No. lamp is turned off in the reduced cylinder mode operation and on in the normal mode operation). [8] 0010 : Fan 70% speed mode q This code forcedly sets the speed of cooling fan at approximately 70% of the maximum speed. q The adjustment data is displayed on the lower line. q How to use: The function is effective with this code dis- played to control the speed of cooling fan to approximately 70% of the maximum speed. a If this code is turned off, its function is dis- abled.

a Only one or more cylinders can be turned off for the reduced cylinder mode opera- tion. a If this code is turned off, its function is dis- abled. [7] 0009 : Pitch angle sensor initial set q This code is used to correct the installation error of the pitch angle sensor by adjusting its zero point. [9] 0021 : KOMTRAX specification set q This code is used to select the installation set- ting of KOMTRAX terminal. a Conduct this setting before the starting operation of KOMTRAX. q The deviation from the standard neutral posi- tion is displayed by voltage on the lower line (Display range: –2500 – 2500). q The terminal installation condition is displayed on the lower line. q Adjustment method:

Stop the machine on level ground, then set buzzer cancel switch (4) in the [ U ] position and check that the alarm buzzer sounds. a Even if the adjustment is carried out, the display of the lower line does not change. a Even if this code is turned off, the setting is effective. q ACTIVE: KOMTRAX is installed. q DEACTIVE: KOMTRAX is not installed. q Setting method: 1) By operating shift up switch (6) and shift down switch (7), select the installation condition of KOMTRAX terminal. 28 D65EX, PX, WX-15E0