SEN00586-00 30 Testing and adjusting [13] 1014 : Steering control lever right set [14] 2222 : HSS lever initial current set q This code is used to adjust the rightmost steer- ing potentiometer position of the PCCS lever. q When the steering start feeling is different by the steering direction, this code is used to adjust the turning radius at the start of steering. q The output signal of the steering potentiometer is displayed by voltage on the lower line (Dis- play range: 0 – 5000). q The current to drive the HSS EPC solenoid is displayed on the lower line [Display range: –350 (Left end) – 0 – 350 (Right end)]. q Adjustment method: 1) Shift the PCCS lever to the steering right stroke end.
2) Set buzzer cancel switch (4) in the [ U ] position and check that the alarm buzzer sounds. a Even if this code is turned off, the setting is effective. a This code is not for the adjustment of the steering performance, etc.. a Even if the adjustment is carried out, the display of the lower line does not change. q Adjustment method: 1) Gradually shifting the PCCS lever to the left or right, display the current to be set and keep it. q If the lever is shifted to the left, the current becomes negative. q If the lever is shifted to the right, the cur- rent becomes positive. 2) Set buzzer cancel switch (4) in the [ U ] position and check that the alarm buzzer sounds.
a As the set current is increased in the posi- tive or negative direction, the turning radius at the start of steering is decreased (the machine turns more quickly). a The below figure is an example that the set current for steering to the left is reduced to increase the turning radius. a Even if this code is turned off, the setting is effective. 30 D65EX, PX, WX-15E0