SEN00587-00 30 Testing and adjusting Testing and adjusting, Part 3 1 Handling of voltage circuit of engine controller 1 Adjustment method when controller has been replaced 1 1. When disconnecting or connecting a connec- tor, be sure to turn off the starting switch. a After the machine is assembled or steering and transmission controller is replaced, adjust the system according to the following proce- dure. k Before connecting the harness connec- tor, be sure to completely remove sand, dust, water, etc., from inside of control- ler side connector. k If the system is not adjusted, the machine may not operate normally and may move suddenly. Accordingly, be sure to adjust it.
a Precautions for replacing a controller: If a controller is replaced, the memory of the oil and filter maintenance mode is reset. Accord- ingly, take a record of the next replacement periods of the oils and filters. a Precautions for replacing a controller: When replacing a controller, stop the machine in a safe place and turn the starting switch off. 2. Do not start the engine with T-adapter inserted in or connected to a connector for trouble- shooting. a You may turn the starting switch to the OFF or ON position but must not turn it to the START position. 1. Setting system in service mode. Turn the starting switch ON and set the monitor panel in the “Adjustment mode” of the service mode.
2. Adjusting steering and transmission con- troller Select steering and transmission controller specification set ( 0002 ) and adjust the steering and transmission controller. 3. Turning power on again. Turn the starting switch OFF then ON, and set the monitor panel in the “Adjustment mode” of the service mode again. 2 D65EX, PX, WX-15E0