30 Testing and adjusting SEN00587-00 4. Adjusting machine specification Select Machine specification set ( 0004 ) and adjust the machine specification. 7. Adjusting KOMTRAX specification Select KOMTRAX specification settings ( 0021 ) and adjust the KOMTRAX specification. 5. Adjusting brake potentiometer Select brake potentiometer initial set ( 0005 ) and adjust the brake potentiometer. 8. Turning power on again. Turn the starting switch OFF then ON. 9. Checking failure codes 1) Set the monitor panel in the “Electric sys- tem failure code display mode” of the ser- vice mode. 2) Check if any active failure codes exist. If not, delete all the failure codes recorded.
a If any active failure codes exist, elimi- nate the cause of the incident by trou- bleshooting, then carry out steps 6 and 7 again. a Precautions after replacing controller: If any controller is replaced, the ser- vice meter in the oil and filter mainte- nance mode is reset to 0. As a result, the replacement period displayed on the monitor panel may be different from the actual operating hours. To solve this problem, deter- mine the first replacement periods of the oils and filters after the replace- ment of the controller according to the replacement periods recorded before the replacement of the controller. 6.
Adjusting pitch angle sensor Select the initial setting ( 0009 ) of the pitch angle sensor and adjust the pitch angle sen- sor. D65EX, PX, WX-15E0 3