SEN00587-00 30 Testing and adjusting Preparation work for troubleshooting for electric system 1 2. Steering and transmission controller 1) Remove left console box inspection cover (1). a When carrying out troubleshooting for an elec- tric circuit related to the monitor panel, engine controller, steering and transmission controller, or KOMTRAX communication modem, expose the related connectors according to the follow- ing procedure. 1. Monitor panel 1) Remove cover (1) above the dashboard. 2) Insert or connect T-adapters in or to con- nectors ST1, ST2 and ST3 of steering and transmission controller (2).
a If the connectors cannot be discon- nected and connected easily, remove the controller from the floor flame. a Since the connectors are secured with screws, loosen those screws before disconnecting. a When connecting the connectors again, tighten their screws with the specified torque. 2) Insert or connect T-adapters in or to con- nectors S03 and S04 on the back side of monitor panel (2). 3 Screw: 2.8 Nm {0.29 kgm} 4 D65EX, PX, WX-15E0