Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — HOW TO START OPERATION OF KOMTRAX TERMINAL

30 Testing and adjusting SEN00587-00 14) Disconnect ACC connector (2). 15) Check that display ( b ) on the monitor panel or KOMTRAX terminal is displayed normally in 5 seconds. a If you can check that the display is [Normal], that is the end of sign-up test. a If the display shows [Abnormal], repeat from procedure 1) again because the sign-up test has not been completed successfully. 2. Application for the start of use a Application for the start of use should be made only after the sign-up test is fin- ished. 1) Notify to the KOMTRAX operations administrator the following information concerning the machine whose sign-up test on the machine side is completed.

(1) Information on the machine whose sign-up test on the machine side is completed (model, model number and serial number) (2) Part number and serial number of the KOMTRAX terminal (3) Reading of the service meter when the KOMTRAX terminal is installed (0.1h unit) 16) Connect ACC connector (2) and turn the buzzer cancel switch to the right to finish the “KOMTRAX LED display” mode. 17) Stop the engine and fix the connector cover with the fixing band. 2) The KOMTRAX operations administrator registers the machine using a KOMTRAX client personal computer. a Refer to “Manual for KOMTRAX oper- ations administrator” for the proce- dure. a Now the terminal is ready for use. D65EX, PX, WX-15E0 23