SEN00587-00 30 Testing and adjusting 11) Turn the starting switch to the starting position, keep it more than 5 seconds, and check that the engine does not start up. a If the engine starts up or the starting switch is turned off, start from proce- dure 1) again. 12) Turn the starting switch to the starting position again, and check that the engine starts up. 13) Check that display ( b ) on the monitor panel or KOMTRAX terminal is displayed normally. a Move on to the next step if you can check that the display is [normal].
(It takes from 90 seconds to 15 min- utes before the display turns normal.) a If [GPS position data detection trou- ble] is indicated, check if there is any abnormality on the GPS antenna or cable. If there is any abnormality, repair it and start from procedure 1) again. a If [Reception trouble] is indicated, check if there is any abnormality on the appearance of the communication antenna or cable. If there is any abnormality, repair it then repeat from procedure 1) again. a If [GPS position data detection trou- ble and reception trouble] is indi- cated, check if there is any abnormality on the GPS antenna/ cable or communication antenna/ cable.
If there is any abnormality, repair it and start from procedure 1) again. a If [Network trouble] is indicated, check the display of [LED-C4] refer- ring to “Lamp display of KOMTRAX terminal”. If the CAN is not recog- nized, check the CAN harness of the KOMTRAX terminal, and then if there is any abnormality, repair it and start from procedure 1) again. [A]: Normal [B]: GPS position data detection trouble [C]: Reception trouble [D]: GPS position data detection trouble and reception trouble [E]: Network trouble 22 D65EX, PX, WX-15E0