Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — HOW TO START OPERATION OF KOMTRAX TERMINAL

30 Testing and adjusting SEN00587-00 6) Check visually that test connector (3) is connected. Monitor panel q Test connector (3): T1F (female) and T1M (male) KOMTRAX terminal 7) Connect ACC connector (2). Keep that condition for 5 seconds. q Check that display ( b ) on the monitor panel or KOMTRAX terminal shows the mark “ – ”. 8) Disconnect test connector (3) and keep that condition for 5 seconds. 9) Reconnect test connector (3) and keep that condition for 5 seconds. [Dot ( a ) blinks on and off] q Blinking of dot ( a ): When the terminal detects insert or removal of the con- nector, dot ( a ) blinks on and off. a Complete procedure 7) – 9) in 30 sec- onds.

10) Check that display ( b ) on the monitor panel or KOMTRAX terminal is displayed normally. a The normal display shows “d” o o “ – ” repeatedly for 30 seconds on the monitor panel after 9) is finished. a Move on to the next step if you can check that the display is [normal]. a If the display is [abnormal], start from procedure 1) again. D65EX, PX, WX-15E0 21