SEN00589-00 40 Troubleshooting Failure code [CA187] Sensor power source 2 too low: Excessively low voltage detected 1 56 D65EX, PX, WX-15E0 Action code Failure code Failure symptom Sensor power source 2 too low: Excessively low voltage detected (Engine controller system) CALL E03 CA187 Failure content • Excessively low voltage has been detected at sensor power source 2 circuit. Controller's action • Operates with a fixed boost pressure. • Operates with fixed charge temperature. • Runs by limiting output. Symptoms that appears on machine • Engine output is reduced. General information • Duplication of failure code: turn ON the starting switch.
Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective sensor or harness a Disconnect connectors with starting switch OFF, then turn it ON for troubleshooting. Disconnect the devices on the right one at a time and try to duplicate the problem. If the failure code changes from flashing to continu- ously illuminating, that device or harness is defective. Boost pressure and temperature sensor C4 Common rail pressure sensor C8 Bkup sensor C13 Engine harness CE01 2 Defective harness connector The connections among each sensor – engine harness – engine controller are suspected to be defective.
• Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded. • Moisture in connector, entry of dirt or sand, etc., and insufficient insulation 3 Defective engine controller Engine controller is possibly defective if no problem is found in causes 1 – 2. (Internal failure which cannot be diagnosed)