Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [CA238] ABNORMAL POWER SOURCE FOR NE SPEED SENSOR: EXCESSIVELY LOW VOLTAGE DETECTED

40 Troubleshooting SEN00589-00 Failure code [CA238] Abnormal power source for Ne speed sensor: Excessively low voltage detected 1 Circuit diagram related to engine Ne speed sensor D65EX, PX, WX-15E0 65 Action code Failure code Failure symptom Abnormal power source for Ne speed sensor: Excessively low volt- age detected (Engine controller system) CALL E03 CA238 Failure content • Excessively low voltage is detected at power source circuit of engine Ne speed sensor. Controller's • action Continues the control by engine Bkup speed sensor signal. Symptoms that • appears • on machine Engine is hard to start. Engine is hunting. General • information Duplication of failure code:

turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting Defective sensor or wiring 1 harness aPrepare with starting switch OFF, then turn it ON for troubleshoot- ing. Disconnect the devices on the right one at a time and try to duplicate the problem. If the failure code changes from flashing to continu- ously illuminating, that device or harness is defective. Ne speed sensor C15 Engine harness CE01 Defective wiring harness 2 connector The connections among each sensor – engine harness – engine controller are suspected to be defective.

• Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded. • Moisture in connector, entry of dirt or sand, etc., and insufficient insulation