SEN00590-00 40 Troubleshooting Failure code [CA449] Common rail pressure too high (2): Excessively high pressure trouble occurred 1 32 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Common rail pressure too high (2): Excessively high pressure trou- ble occurred (Engine controller system) CALL E03 CA449 Failure content • Excessively high pressure trouble (2) has occurred in the common rail circuit. Controller's action • Operates with limited output. Symptoms that appears on machine • Engine noise becomes louder at no or light load. • Engine output is reduced. General information • Common rail pressure can be checked with the monitoring function. (Code:
36400 Common rail pressure) • Duplication of failure code: Start the engine. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective related circuits Check the failure codes that are displayed at the same time. If any other codes are displayed, carry out troubleshooting for those codes. 2 Air in the low pressure circuit Air has possibly entered into the low pressure circuit, so inspect directly in the following procedure: 1) Remove pressure inspection plug (on the outlet port) for the fuel main filter. 2) Operate the feed pump for the fuel pre-filter.
3) Inspect the fuel and air leaking from the pressure inspection plug. • If this error occurs during the air bleeding operation after the fuel filter replacement, air is possibly remaining in the fuel cir- cuit, so continue to run the engine at low idle for approximately 3 minutes. When air bleeding is complete, engine revolutions become stable and the error display disappears. 3 Defective fuel low pressure circuit devices aRefer to Testing and adjusting “Fuel Pressure Inspection” for fuel low pressure circuit pressure inspection. • Measurement on the outlet side of the fuel filter Fuel low pressure circuit pressure At high idle (When engine can be started) Min. 0.48 MPa {Min.
4.9 kg/cm2} • Measurements on the inlet and outlet sides of the fuel filter • Fuel low pressure circuit pressure drop = fuel filter inlet pressure – fuel filter outlet pressure Fuel low pressure circuit pressure drop At high idle Max. 0.14 MPa {Max. 1.4 kg/cm2} aRefer to Testing and adjusting “Fuel Pressure Inspection” for fuel suction pressure inspection. • Measurement on the gear pump fuel inlet side of the supply pump Fuel suction circuit pressure (Gear pump side) At high idle Max. 33.9 kPa {Max. 254 mmHg} • Measurement on the fuel connector side Fuel suction circuit pressure (Fuel connector side) At high idle Max. 27.1 kPa {Max.
203 mmHg} 4 Defective fuel cooler aInspect directly if fuel is leaking from the fuel tube for fuel cooler, if O-ring or seal washer is damaged, or if check valve is clogged or damaged.