SEN00590-00 40 Troubleshooting Failure code [CA757] Loss of all engine controller data: Loss of all data 1 48 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Loss of all engine controller data: Loss of all data (Engine controller system) CALL E04 CA757 Failure content • Loss of all data in engine controller has been detected. Controller's action • No particular action Symptoms that appears on machine • Engine may stop and can not restart. • Monitoring function of monitor panel (engine controller system) may not operate normally. General information • Duplication of failure code: turn ON the starting switch.
Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective related circuits Check the failure codes that are displayed at the same time. If any other codes are displayed, carry out troubleshooting for those codes. 2 Loose or corroded battery terminal Battery terminal is possibly loose or corroded, so inspect it directly. 3 Defective battery voltage aPrepare with starting switch OFF and diagnose with starting switch OFF and START. Battery (1 unit) Starting switch Voltage Between (+) – (–) terminals OFF Min. 12 V START Min. 6.2 V 4 Defective fuse No.
9 If fuse is blown, it is highly possible that a defective harness ground- ing, etc. has occurred in the circuit. 5 Disconnection in wiring harness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between FS2 (9) – CE03 (female) (3), (4) Resis- tance Max. 10 z Wiring harness between CE03 (female) (1), (2) – ground 1 Resis- tance Max. 10 z 6 Defective wiring harness connector Since the problem is possibly at the connections between FS2 (9) – body harness – engine controller, check for a defective connection.
• Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded. • Moisture in connector, entry of dirt or sand, etc., and insufficient insulation 7 Defective engine controller aPrepare with starting switch OFF and diagnose with starting switch ON and START. CE03 (female) Starting switch Voltage Between (3), (4) – (1), (2) ON Min. 24 V START Min. 12 V