SEN00281-01 10 Structure, function and maintenance standard Function q The pump converts the engine rotation trans- mitted to its shaft to oil pressure and delivers pressurized oil corresponding to the load. q It is possible to change the discharge amount by changing the swash plate angle. Structure q Cylinder block (7) is supported to shaft (1) by spline (a), and shaft (1) is supported by the front and rear bearings. q The tip of piston (6) is a concave ball, and shoe (5) is caulked to it to form one unit. Piston (6) and shoe (5) form a spherical bearing. q Rocker cam (4) has flat surface (A), and shoe (5) is always pressed against this surface as it slides in a circle.
Rocker cam (4) also slides around ball (11) using it as fulcrum. q Piston (6) carries out relative movement in the axial direction inside each cylinder chamber of cylinder block (7). q Cylinder block (7) carries out rotation relative to valve plate (8) while sealing the pressurized oil, and this surface ensures that the hydraulic balance is maintained correctly. q The oil inside each cylinder chamber of cylin- der block (7) is sucked in and discharged through valve plate (8). 6 D65EX, PX, WX-15E0