Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [DK10KA] FUEL DIAL: DISCONNECTION

SEN00591-00 40 Troubleshooting Failure code [DK10KA] Fuel dial: Disconnection 1 56 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Fuel dial: Disconnection (Steering and transmission controller system) CALL E03 DK10KA Failure content • Signal voltage of fuel dial circuit is less than 0.5 V. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Continues to keep it under control with decelerator pedal potentiometer signal. • Operation of engine and transmission is limited. Symptoms that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1.

General information • Input status (voltage) from fuel dial can be checked in monitoring mode. (Code 03000: Fuel dial voltage) • Duplication of failure code: turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective sensor 5 V power source system Check displays of failure codes [DAQ5KK] [DB35KK] and if there is any display, carry out that troubleshooting first. 2 Defective fuel dial (Internal disconnection and short circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF.

DIAL (male) Resistance Between (A) – (C) 4.0 – 6.0 kz Between (A) – (B) 0.5 – 4.5 kz Between (B) – (C) 0.5 – 4.5 kz 3 Disconnection in wiring harness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (22) – DIAL (female) (A) Resis- tance Max. 1 z Wiring harness between ST1 (female) (1) – DIAL (female) (B) Resis- tance Max. 1 z 4 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (22) – DIAL (female) (A) with ground Resis- tance Min.

1 Mz Wiring harness between ST1 (female) (1) – DIAL (female) (B) with ground Resis- tance Min. 1 Mz 5 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch ON. ST1 Voltage Between (22) – (21) 4.6 – 5.4 V Between (1) – (21) 0.5 – 4.5 V