Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [DK31KA] STEERING POTENTIOMETER (2): DISCONNECTION

SEN00591-00 40 Troubleshooting Failure code [DK31KA] Steering potentiometer (2): Disconnection 1 66 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Steering potentiometer (2): Disconnection (Steering and transmission controller system) CALL E03 DK31KA Failure content • Signal voltage of steering potentiometer (2) system is less than 0.5 V. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Continues to keep it under control with signal of steering potentiometer (1) system. • Limits operation of engine and transmission. Symptoms that appears on machine • Once machine is stopped, engine speed is limited to medium (half).

• Once machine is stopped, travel is limited to F1 and R1. General information • Input status (voltage) from steering potentiometer (2) can be checked in monitoring mode. (Code 50301: Steering potentiometer (2) voltage) • Method of reproducing failure code: Turn starting switch ON + (Shift PCCS lever (steering)) Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective sensor power source system Check displays of failure codes [DAQ5KK] [DB35KK] and if there is any display, carry out that troubleshooting first.

2 Defective steering potenti- ometer (2) (Internal discon- nection and short circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. TL2 (male) Resistance Between (5) – (8) 3.2 kz ± 20% Between (6) – (5) 6 – 1 z (right – left steering) Between (6) – (8) 1 – 6 z (right – left steering) 3 Disconnection in wiring harness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (22) – TL2 (female) (5) Resis- tance Max. 1 z Wiring harness between ST1 (female) (19) – TL2 (female) (6) Resis- tance Max.

1 z 4 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (19) – TL2 (female) (6) with ground Resis- tance Min. 1 Mz 5 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch ON. ST1 Voltage Between (19) – (21) 0.5 – 4.5