40 Troubleshooting SEN00591-00 Failure code [DK30KZ] Steering potentiometer: Disconnection or short circuit (Double failure) 1 Failure code [DK30L8] Steering potentiometer: Inconsistent analog signal 1 D65EX, PX, WX-15E0 65 Action code Failure code Symptom of failure Steering potentiometer: Disconnection or short circuit (Steering and transmission controller system) CALL E04 DK30KZ Failure content • At steering potentiometer systems 1 and 2, when starting switch was turned ON, only either of them showed abnormality and later, either failure code [DK30KA] or [DK30KB] or either failure code [DK31KA] or [DK31KB] occurred at the same time.
Controller's action • Flashes warning lamp and turns on alarm buzzer. • Limits operation of engine, transmission and brake. Symptoms that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, it becomes impossible to travel. General information • Input status (voltage) from steering potentiometer can be checked in monitoring mode. (Code 50300: Steering potentiometer 1 voltage) (Code 50301: Steering potentiometer 2 voltage) • Method of reproducing failure code:
Turn starting switch ON + (Shift PCCS lever (steering)) Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting Carry out troubleshooting for failure code [DK30KA] [DK30KB] [DK31KA] [DK31KB] Action code Failure code Symptom of failure Steering potentiometer: Inconsistent analog signal (Steering and transmission controller system) CALL E03 DK30L8 Failure content • Total signal voltage of steering potentiometer systems 1 and 2 is less than 4.41 V or more than 5.59 V. Controller's action • Flashes warning lamp and turns on alarm buzzer.
• Continues to keep it under control with the normal signal of either steering potentiometer system 1 or 2. • Limits operation of engine and transmission. Symptoms that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1. General information • Input status (voltage) from steering potentiometer can be checked in monitoring mode. (Code 50300: Steering potentiometer 1 voltage) (Code 50301: Steering potentiometer 2 voltage) • Method of reproducing failure code:
Turn starting switch ON + (Shift PCCS lever (forward-reverse)) Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting Carry out troubleshooting for failure code [DK30KA] [DK30KB] [DK31KA] [DK31KB]