Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [DKH1KB] [DKH1KX] PITCH ANGLE SENSOR: DISCONNECTION

SEN00592-00 40 Troubleshooting Failure code [DKH1KB] [DKH1KX] Pitch angle sensor: Disconnection 1 4 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Pitch angle sensor: Disconnection (Steering and transmission controller system) CALL E03 DKH1KB DKH1KX Failure content • Signal voltage of pitch angle sensor is below 0.15 V. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Cannot recognize pitch angle. • Limits operation of engine and transmission. Symptoms that appears on machine • Excessive gear shift shock is felt on a slope. • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1.

General information • Both DKH1KB and DKH1KX are displayed. • Input state (voltage) from pitch angle sensor can be checked in monitoring mode. (Code 60100: Voltage of pitch angle sensor) • Duplication of failure code: turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective sensor 24 V power supply circuit Check if failure code [DAQ6KK] or [DB36KK] is displayed. If it is displayed, carry out troubleshooting for it first. 2 Defective pitch angle sensor (internal defect) aPrepare with starting switch OFF and diagnose with starting switch ON.

PT1 Voltage Between (B) – (A) 0.15 – 4.85 V 3 Disconnection in wiring har- ness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (16) – PT1 (female) (C) Resis- tance Max. 1 z Wiring harness between ST1 (female) (8) – PT1 (female) (B) Resis- tance Max. 1 z 4 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Between ground and wiring harness between ST1 (female) (8) – PT1 (female) (B) Resis- tance Min.

1 Mz 5 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch ON. ST1 Voltage Between (8) – (21) 0.15 – 4.85 V