40 Troubleshooting SEN00592-00 Failure code [DXA0KA] HSS pump TVC solenoid: Disconnection 1 Circuit diagram of HSS pump TVC solenoid D65EX, PX, WX-15E0 23 Action code Failure code Symptom of failure HSS pump TVC solenoid: Disconnection (Steering and transmission controller system) E01 DXA0KA Failure conte • Any current does not flow when power is output to HSS and work equipment pump TVC solenoid cir- nt cuit. Controller's action • Stops outputting power to HSS and work equipment TVC solenoid circuit. Symptoms th appears on machin at • When load is applied while engine is running at low speed, engine will stall.
e General information • Output state (current) to HSS and work equipment pump TVC solenoid left can be checked in moni- toring mode. (Code 01300, 01301: Output current of TVC solenoid) • Duplication of failure code: turn ON the starting switch.
Possible causes and t standard valu when norm Cause Defective HSS and work 1 equipment pump TVC sole- noid (Internal disconnection) he Disconnection in wiring harnes es 2 (Disconnection or defective al contact of connectors) Defective steering and 3 transmission controller Standard value when normal and remarks for troubleshooting Defective HSS and work quipment pump TVC sole- oid (Internal disconnection) aPrepare with starting switch OFF and diagnose with starting switch still OFF.
HSP (male) Resistance Between (1) – (2) 9 – 19 z Resistance 9 – 19 z Disconnection in wiring harnes Disconnection or defective ontact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. s Wiring harness between ST3 (female) (7) – Resis- Max. 1 z HSP (female) (1) tance Wiring harness between ST3 (female) (3) – Resis- Max. 1 z HSP (female) (2) tance Resis- Ma tance x. 1 z Resis- Ma tance x. 1 z Defective steering and ransmission controller aPrepare with starting switch OFF and diagnose with starting switch still OFF. ST3 (female) Resistance Between (7) – (3) 9 – 19 z Resistance 9 – 19 z