40 Troubleshooting SEN00593-00 Contents of troubleshooting table 1 a The following information is summarized in the troubleshooting table and the related electrical circuit diagram. Before carrying out troubleshooting, understand that information fully. Related circuit diagram This is the excerpted circuit diagram related to troubleshooting. Connector No.: Indicates (model – number of pins) (color) Indication of “Connector No. and Pin No.” from the branch or junction point: Indicates the branch destination or the splice location in the same harness Arrow ( ) :
Indicates the approximate mounting place on machine D65EX, PX, WX-15E0 5 Symptom of failure Symptom of failure that has appeared in the machine General information Information related to troubles occurred or troubleshooting Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Cause by which a trouble is assumed to be caused (The order number indi- cates a serial number, not a priority sequence.) • Standard value when normal required to judge the possible cause • Remarks required to judge whether the cause is right or not • Disconnection in wiring The connector contact is defective or the wiring harness is disconnected.
• Defective grounding A harness not connected to GND (ground) circuit comes into contact with the GND (ground) circuit. • Hot short defect A harness not connected to the electric power supply (24 V) circuit comes into contact with the electric power supply (24 V) circuit. • Short circuit A harness abnormally comes into contact with a harness of separate circuit. (1) Method of indicating connector numbers and handling T- adapter For troubleshooting, insert or connect the T- adapter as described below unless especially specified. • When “male” or “female” is not indicated for a connector number, disconnect the connector, and insert the T- adapter in both the male and female.
• When “male”or “female” is indicated for a connector num- ber, disconnect the connector, and insert the T-adapter in only either the male or female. (2) Pin number description sequence and tester lead handling For troubleshooting, connect the plus (+) and minus (–) leads of the tester as described below unless especially specified. • Connect the plus (+) lead to a pin number or harness indi- cated in the front. • Connect the minus (–) lead to a pin number or harness indicated in the rear. 2 3 4