SEN00593-00 40 Troubleshooting E-3 The monitor panel does not light up at all when the starting switch is turned ON. 1 Circuit diagram related to electric power supply to monitor panel 14 D65EX, PX, WX-15E0 Sympto failur • If “the battery relay does not make operating sound” when the starting switch is turned on, the main m of electric power supply system is supposed to be defective. So, check the main electric power supply e system. • The monitor panel does not light up at all when the starting switch is turned ON.
Gener informat al • When the starting switch is turned ON, the gear speed indicator, multi-information section, gauge ion section, and lamp section light up for approximately 2 sec. and then go out. Possib causes an standard v when no Cause Wh 1 Defective fuse FS2-7 fault aP s Wiri Disconnection in wiring harness start 2 (Disconnection or defective Wiri contact of connectors) fuse Bet le S03 d the alues aP rmal s Defective harness grounding Bet 3 (Contact with ground circuit) (fem Bet S03 aP s 4 Defective monitor panel Standard value when normal and remarks for troubleshooting Wh Defective fuse FS2-7 fault en the fuse FS2-7 is blown, the circuit probably has a grounding .
aP s Wiri Disconnection in wiring harness start (Disconnection or defective Wiri contact of connectors) fuse Bet S03 repare with starting switch OFF and diagnose with starting witch still OFF. ng harness between S03 (female) (1) (2) – R ing switch 270 (ACC) ta esis- nce Max. 1 z ng harness between S03 (female) (5) (6) – R FS2-7 ta esis- nce Max. 1 z ween ground and wiring harness between R (female) (3) (4) – GND01 ta esis- nce Max. 1 z aP s Defective harness grounding Bet (Contact with ground circuit) (fem Bet S03 repare with starting switch OFF and diagnose with starting witch still OFF. ween ground wiring harness between S03 R ale) (1) (2) – starting switch 270 (ACC) ta esis- M nce in.
1 Mz ween ground and wiring harness between R (female) (5) (6) – fuse FS2-7 ta esis- M nce in. 1 Mz aP s Defective monitor panel repare with starting switch OFF and diagnose with starting witch ON. S03 Voltage Between (1) (2) – (3) (4) 20 – 30 V Between (5) (6) – (3) (4) 20 – 30 V