Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — E-6 WHILE THE ENGINE IS RUNNING, THE EMERGENCY WARNING ITEM FLASHES.

40 Troubleshooting SEN00593-00 D65EX, PX, WX-15E0 19 Symptom of failure (3) The power train oil temperature caution lamp flashes. General information • When any abnormality is detected while engine is running, the power train oil temperature caution lamp flashes and the alarm buzzer sounds. • The power train oil temperature caution lamp flashes or goes out in accordance with indication on the power train oil temperature gauge. • The input state (temperature) from the power train oil temperature sensor can be checked in the monitoring mode. (Code 30100: Power train oil temperature) • Before starting the troubleshooting, validate that the related failure code is not displayed.

(If the failure code [DGT1KA] or [DGT1KX] is displayed, firstly diagnose the displayed code.) Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Power train oil temperature overheats (When system is normal) Since the power train oil overheat is detected, check the power train oil temperature. (At the oil temperature over 130°C, the lamp flashes and the buzzer sounds. Over 120°C, just the lamp flashes.) 2 Defective power train oil tem- perature sensor circuits (Monitor panel circuit) When the cause 1 is not the real cause, the power train oil tempera- ture sensor circuit is supposed to be defective.

So, carry out the troubleshooting of “E-9 The power train oil temperature gauge does not indicate correctly.” 3 Defective monitor panel Since this is an internal defect, it cannot be diagnosed. Symptom of failure (4) The hydraulic oil temperature caution lamp flashes. General information • When any abnormality is detected while engine is running, the hydraulic oil temperature caution lamp flashes and the alarm buzzer sounds. • The hydraulic oil temperature caution lamp flashes or goes out in accordance with indication on the hydraulic oil temperature gauge. • The input state (temperature) from the hydraulic oil temperature sensor can be checked at monitor- ing mode. (Code 04401:

Hydraulic oil temperature) • Before starting the troubleshooting, validate that the related failure code is not displayed. (If the failure code [DGS1KX] is displayed, firstly diagnose the displayed code.) Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Hydraulic oil overheats (When system is normal) Since the hydraulic oil overheat is detected, check the hydraulic oil temperature. (At the hydraulic oil temperature over 110°C, the lamp flashes and the buzzer sounds.

Over 100°C, just the lamp flashes.) 2 Defective hydraulic oil tem- perature sensor circuit (Monitor panel circuit) When the cause 1 is not the real cause, the hydraulic oil tempera- ture sensor circuit is supposed to be defective. So, carry out the troubleshooting of “E-10 The hydraulic oil temperature gauge does not indicate correctly” 3 Defective monitor panel Since this is an internal defect, it cannot be diagnosed.