SEN00593-00 40 Troubleshooting 56 D65EX, PX, WX-15E0 Symptom of failure (3) The rear wiper does not operate (Continuous operation is defective) General information • When only the rear wiper is defective • If any wiper does not operate, check fusible link (FL1). • Diagnose with intermittent switch OFF and with wiper switch ON. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective fusible link (FL1) If the fusible link is burnout, the circuit probably has a grounding fault, etc.
2 Defective fuse (4) in cab Since fuse (4) in the cab is used only for the rear wiper circuit, the rear wiper circuit probably has a grounding fault, etc. 3 Defective rear wiper motor aPrepare with starting switch OFF and diagnose with starting switch ON. Between CN37 (1) – ground Voltage 20 – 30 V aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between CN37 (female) (2) – ground Resis- tance Max. 1 z 4 Defective rear wiper switch aPrepare with starting switch OFF and diagnose with starting switch still OFF. CN12 (male) Position of switch Resistance Between (3) – (4) ON Max. 1 z OFF Min.
1 Mz 5 Defective rear wiper intermit- tent selector relay • If the problem is eliminated by replacing the relay (CN27), (CN29) or (CN31) with another one, the relay is defective. aPrepare with starting switch OFF and diagnose with starting switch ON. Between CN33 (3) – ground Voltage 20 – 30 V Between CN33 (6) – ground Voltage 20 – 30 V Between CN33 (1) – ground Voltage Max. 1 V 6 Defective rear wiper intermittent relay • If the problem is eliminated by replacing the relay (CN26), (CN28) or (CN30) with another one, the relay is defective. aPrepare with starting switch OFF and diagnose with starting switch ON.
Between CN32 (4) – ground Voltage 20 – 30 V Between CN32 (3) – ground Voltage 20 – 30 V Between CN32 (5) – ground Voltage 20 – 30 V