SEN00593-00 40 Troubleshooting 58 D65EX, PX, WX-15E0 Symptom of failure (4) Rear wiper malfunctions in the intermittent mode. General information • When the ordinary operation is normal. • When carrying out the troubleshooting, turn the wiper switch and intermittent switch ON. • The wiper stops for about 5 seconds after a single wiping operation. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective intermittent switch • If the ordinary operation is normal and the other wiper also mal- functions in the intermittent mode, the intermittent switch is prob- ably defective.
aPrepare with starting switch OFF and diagnose with starting switch still OFF. CN11 (male) Position of switch Resistance Between (1) – (2) ON Max. 1 z OFF Min. 1 Mz 2 Defective rear wiper intermit- tent selector relay • If the problem is eliminated by replacing the relay (CN27), (CN29) or (CN31) with another one, the relay is defective. aPrepare with starting switch OFF and diagnose with starting switch ON. Between CN33 (1) – ground Voltage 20 – 30 V Between CN33 (5) – ground Voltage 20 – 30 V 3 Defective rear wiper intermit- tent relay • If the problem is eliminated by replacing the relay (CN26), (CN28) or (CN30) with another one, the relay is defective.
aPrepare with starting switch OFF and diagnose with starting switch ON. Between CN32 (2) – ground Voltage 20 – 30 V 4 Disconnection or short circuit with ground in wiring harness (Disconnection in wiring or defective contact in connec- tor or contact with ground cir- cuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between CN11 (female) (2) – CN33 (female) (1) Resis- tance Max. 1 z Between ground and wiring harness between CN11 (female) (2) – CN33 (female) (1) Resis- tance Min. 1 Mz Wiring harness between CN33 (female) (5) – CN32 (female) (2) Resis- tance Max.
1 z Between ground and wiring harness between CN33 (female) (5) – CN32 (female) (2) Resis- tance Min. 1 Mz Wiring harness between CN33 (female) (2) – ground Resis- tance Max. 1 z