SEN00593-00 40 Troubleshooting * For the electric diagram of each system, see Symptom of failure (1). 70 D65EX, PX, WX-15E0 Symptom of failure (2) Rear washer does not spray water General information • When the rear wiper operates normally (If the wiper does not operate either, carry out troubleshooting in “E-25 (3) The rear wiper does not operate.” first.) Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective rear washer motor aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between 12 (female) (1) – ground Resis- tance Max.
1 z aPrepare with starting switch OFF and diagnose with starting switch ON. (switch position: W/I) Between 12 (2) – ground Voltage 20 – 30 V 2 Defective rear wiper switch aPrepare with starting switch OFF and diagnose with starting switch still OFF. CN12 (female) Position of switch Resistance Between (2) – (1) W/I or W/II Max. 1 z OFF Min. 1 Mz 3 Disconnection or short circuit with ground in wiring harness (Disconnection in wiring or defective contact of connec- tors or contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between fuse (4) – CN12 (female) (2) Resis- tance Max.
1 z Between ground and wiring harness between fuse (4) – CN12 (female) (2) Resis- tance Min. 1 Mz Wiring harness among CN12 (female) (1) – 19 (4) – 13 (4) – 12 (female) (2) Resis- tance Max. 1 z Between ground and wiring harness among CN12 (female) (1) – 19 (4) – 13 (4) – 12 (female) (2) Resis- tance Min. 1 Mz Wiring harness between 12 (female) (1) – ground Resis- tance Max. 1 z