Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — H-1 THERE IS NO TRAVEL POWER (NO DRAWBAR PULL).

SEN00594-00 40 Troubleshooting H-1 There is no travel power (no drawbar pull). 1 4 D65EX, PX, WX-15E0 Symptom of failure • There is no travel power (no drawbar pull). General information • Check that the power train oil level is normal before troubleshooting. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective engine aPrepare with the starting switch OFF, and then run the engine at high idle for troubleshooting. Measurement conditions Engine speed F3 stall 1,650 rpm 2 Defective power train pump The power train pump is assumed to be defective; visually check it.

3 Internally defective torque converter aPrepare with the starting switch OFF, and then run the engine at high idle for troubleshooting. PCCS lever Torque converter inlet pressure Torque converter outlet pressure Full neutral Max. 0.88 MPa {Max. 9 kg/cm2} 0.39 – 0.69 MPa {4 – 7 kg/cm2} 4 Defective set pressure or internal defect of transmis- sion main relief valve aPrepare with the starting switch OFF, and then run the engine at high idle for troubleshooting. PCCS lever Transmission main relief pressure Full neutral Min. 3.04 MPa {Min. 31 kg/cm2} aPrepare with starting switch OFF and diagnose with starting switch still OFF.

Visually check that the free length of spring and the number of shims are normal and also that the spool rotates smoothly. • Free length of large spring: 128 mm • Free length of small spring: 108 mm • Number of shims: 6 5 Defective operation of trans- mission valve (ECMV) aPrepare with the starting switch OFF, and then run the engine at low idle for troubleshooting. Transmission clutch Clutch pressure FWD Min. 2.84 MPa {Min. 29 kg/cm2} REV Min. 2.84 MPa {Min. 29 kg/cm2} 1ST Min. 2.84 MPa {Min. 29 kg/cm2} 2ND Min. 2.84 MPa {Min. 29 kg/cm2} 3RD Min. 2.84 MPa {Min. 29 kg/cm2} 6 Defective brake valve aPrepare with the starting switch OFF, and then run the engine at high idle for troubleshooting.

Parking lever Brake pressure Free Min. 2.55 MPa {Min. 26 kg/cm2} 7 Parking lever or brake pedal linkage out of adjustment If the result of the troubleshooting in cause 6 is abnormal, the park- ing lever or brake pedal linkage is assumed to be out of adjustment; visually check it. 8 Internally defective transmission The transmission is assumed to be defective internally; visually check it.