Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — H-5 WHEN GEAR IS SHIFTED OR TRAVEL DIRECTION IS CHANGED, LARGE TIME LAG IS MADE

SEN00594-00 40 Troubleshooting H-5 When gear is shifted or travel direction is changed, large time lag is made 1 8 D65EX, PX, WX-15E0 Symptom of failure • Time lag is excessive when shifting gear or changing direction. General information • Check that the power train oil level is normal before troubleshooting. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective power train pump The power train pump is assumed to be defective; visually check it.

2 Defective set pressure or internal defect of transmis- sion main relief valve aPrepare with the starting switch OFF, and then run the engine at high idle for troubleshooting. PCCS lever Transmission main relief pressure Full neutral Min. 3.04 MPa {Min. 31 kg/cm2} aPrepare with starting switch OFF and diagnose with starting switch still OFF. • Visually check that the free length of spring and the number of shims are normal and also that the spool rotates smoothly. • Free length of large spring: 128 mm • Free length of small spring: 108 mm • Number of shims:

6 3 Defective operation of trans- mission valve (ECMV) aPrepare with the starting switch OFF, and then run the engine at low idle for troubleshooting. (Before this, check that the transmission main relief pressure is normal.) Transmission clutch Clutch pressure FWD Min. 2.84 MPa {Min. 29 kg/cm2} REV Min. 2.84 MPa {Min. 29 kg/cm2} 1ST Min. 2.84 MPa {Min. 29 kg/cm2} 2ND Min. 2.84 MPa {Min. 29 kg/cm2} 3RD Min. 2.84 MPa {Min. 29 kg/cm2} 4 Defective transmission clutch seal If the result of the troubleshooting in cause 3 is abnormal, the clutch seal is assumed to be defective; visually check it.

5 Internally defective transmission clutch The transmission clutch is assumed to be defective internally; visu- ally check it. 6 Defective operation of brake (Dragging) aMove to a flat place (a hard road), and start the engine for trou- bleshooting. If the machine does not run by low idle + F2 operation, brake drag- ging occurs. (Carry out troubleshooting “H-8 Brake does not work”.)