SEN00594-00 40 Troubleshooting H-14 Blade tilt speed is slow or lacks power 1 H-15 Ripper lift speed is slow or lacks power 1 14 D65EX, PX, WX-15E0 Symptom of failure • Blade tilt speed is slow or lacks power. General information • Check that the oil level in the hydraulic tank is normal before troubleshooting. • Check for modifications to the blade. • If the hydraulic drift of blade tilt is also excessive, carry out the troubleshooting of "H-17 Excessive hydraulic drift of blade tilt" first.
Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective operation of PPC valve aPrepare with the starting switch OFF, and then run the engine at high idle for troubleshooting. Blade control lever PPC valve output pressure Tilt stroke end 3.53 – 4.41 MPa {36 – 45 kg/cm2} 2 Defective operation of blade tilt control valve (spool) The operation of the blade tilt control valve spool is assumed to be defective; visually check it. 3 Residual air in blade tilt cylin- der Residual air is assumed to remain in the blade tilt cylinder; bleed air and observe how the phenomenon changes.
Symptom of failure • Ripper lift speed is slow or lacks power. General information • Check that the oil level in the hydraulic tank is normal before troubleshooting. • Check for modifications to the ripper. • If the hydraulic drift of ripper lift is also excessive, carry out the troubleshooting of "H-18 Excessive hydraulic drift of ripper lift" first. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective operation of PPC valve aPrepare with the starting switch OFF, and then run the engine at high idle for troubleshooting.
Ripper control lever PPC valve output pressure Lift stroke end 3.53 – 4.41 MPa {36 – 45 kg/cm2} 2 Defective operation of ripper lift control valve (spool) The operation of the ripper lift control valve spool is assumed to be defective; visually check it. 3 Defective operation of ripper lift control valve (suction valve) The operation of the suction valve of the ripper lift control valve is assumed to be defective; visually check it. aAs one method, replace the suction valve at the head with the one at the bottom, and observe how the phenomenon changes.
4 Residual air in ripper lift cylin- der Residual air is assumed to remain in the ripper lift cylinder; bleed air and observe how the phenomenon changes.