Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — S-4 ENGINE STOPS DURING OPERATIONS

40 Troubleshooting SEN00595-00 S-4 Engine stops during operations 1 *1: Failure code of code display [CA559] and [CA2249] D65EX, PX, WX-15E0 11 General causes why engine stops • Internal part of engine seized • Insufficient supply of fuel • Engine overheating • Failure in power train on the machine: Carry out troubleshooting on the machine.

Cause Broken dynamic valve system (valve, rocker lever, etc.) Broken, seized piston, connecting rod Broken, seized crankshaft bearing Broken, seized gear train Insufficient fuel in tank Clogged air breather hole in fuel tank cap Clogged, leaking fuel piping Clogged fuel filter Broken, seized fuel feed pump Broken fuel supply pump shaft Stuck, seized fuel supply pump plunger Broken auxiliary equipment (pump, compressor, etc.) Failure in power train mounted on the machine Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E Condition when engine stopped Abnormal noise was heard and engine stopped suddenly w w w w Q w Q w w Engine overheated and stopped w Q Q Engine stopped slowly w Q There was hunting and engine stopped w Q Q Q Non-specified fuel is being used Q Q Q Replacement of filters has not been carried out according to Operation & Maintenance Manual w Fuel level monitor indicates low fuel remaining (when monitor is installed) w Fuel tank is found to be empty w Air breather hole in fuel tank cap is clogged w There is a leakage from fuel piping w Rust and water are found when fuel in fuel tank is drained w Metal particles are found when oil in oil pan is drained w w w Q When it is attemped to turn engine by hand Does not turn at all w w Turns in opposite direction w Moves amount of backlash w w Fuel supply pump shaft does not run w Engine rotates but stops when load is applied to machine w Troubleshooting Check dynamic valve system directly q Carry out troubleshooting on the machine Check piston and connecting rod directly q Check crankshaft bearing directly q Check gear train directly q Check fuel filter, strainer directly q Check fuel feed pump directly q Carry out troubleshooting for code display “Supply pump pressure no signal (*1)“ q q When auxiliary equipment (pump, air compressor, etc.) is removed, engine turns q Action Replace Replace Replace Replace Add Clean Correct Replace Replace Replace Replace Replace —