SEN00595-00 40 Troubleshooting S-3 Engine does not pick up smoothly 1 *1:
Failure code of code display [CA559] and [CA2249] 10 D65EX, PX, WX-15E0 General causes why engine does not pick up smoothly • Insufficient intake of air • Insufficient supply of fuel • Abnormal fuel injection condition • Improper selection of fuel • Controller controlled by derate mode (The injection amount (output) is limited because a failure has occurred in the electrical system.) Cause Clogged air cleaner element Defective contact of valve and valve seat Improper valve clearance Seized turbocharger, interference Worn piston ring, cylinder liner Clogged air breather hole in fuel tank cap Leakage, clogging, air in fuel piping Clogged fuel filter Stuck, seized fuel supply pump plunger Clogged injector, defective spray Check items Questions Confirm recent repair history Degree of use of machine Operated for long period E E E E Engine pick-up suddenly becomes poor w Q Q Q Non-specified fuel is being used w w w Replacement of filters has not been carried out according to Operation & Maintenance Manual w w Engine oil must be added more frequently w Dust indicator lamp is red (when indicator is installed) w Air breather hole in fuel tank cap is clogged w Rust and water are found when fuel in fuel tank is drained w There is a leakage from fuel piping w When exhaust manifold is toutched immediately after starting engine, temperature of some cyl- inders is low Q w Color of exhaust gas Blue under light load w Black w Q w w When engine is running, abnormal noise is heard from around cylinder head w When engine is running, noise of interference is heard from around turbocharger w High idle speed is normal, but speed suddenly drops when load is applied Q w There is hunting from engine (rotation is irregular) Q Q Q Blow-by gas is excessive w Troubleshooting Check air cleaner directly q When compression pressure is measured, it is found to be low q q Check valve clearance directly q When turbocharger is rotated by hand, it is found to be heavy q When air is bled from fuel line, air comes out q Check fuel filter, strainer directly q Carry out troubleshooting for code display “Supply pump pressure no signal (*1)“ q Engine speed does not change when operation of certain cylinders is stopped in reduced cylin- der mode q Action Clean Replace Adjust Replace Replace Clean Correct Replace Replace Replace