Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — S-6 ENGINE LACKS OUTPUT (OR LACKS POWER)

40 Troubleshooting SEN00595-00 S-6 Engine lacks output (or lacks power) 1 *1: Failure code of code display [CA559] and [CA2249] *2: Failure code of code display [CA112] and [CA123] D65EX, PX, WX-15E0 13 General causes why engine lacks output • Insufficient intake of air • Insufficient supply of fuel • Abnormal fuel injection condition • Improper selection of fuel • Engine overheating:

See “S-14 Coolant temperature becomes too high (over- heating)“ • Controller controlled by derate mode (The injection amount (output) is limited because a failure has occurred in the electrical system.) Cause Clogged air cleaner element Leakage in air intake piping Seized turbocharger, interference Defective contact of valve and valve seat Improper valve clearance Worn piston ring, cylinder liner Clogged air breather hole in fuel tank cap Clogged, leaking fuel piping Clogged fuel filter Stuck, seized fuel supply pump plunger Clogged fuel injector, defective spray (dirt caught) Defective injector drive (signal, solenoid) Defective mount of boost pressure sensor (air leakage) Defective boost pressure sensor, defective wiring harness Clogged fuel spill piping Check items Questions Confirm recent repair history Degree of use of machine Operated for long period E E E E Power was lost Suddenly Q w Q Q Q Q Gradually Q Q Q Q Q Q Non-specified fuel is being used Q Q Q Replacement of filters has not been carried out according to Operation & Maintenance Manual w w Engine oil must be added more frequently Q Q Dust indicator lamp is red (when indicator is installed) w w Air breather hole in fuel tank cap is clogged w There is a leakage from fuel piping w Power is lacking after short stop in operations w Color of exhaust gas Black w w Blue under light load w When exhaust manifold is touched immediately after starting engine, temperature of some cylinders is low w w When engine is running, noise of interference is heard from around turbocharger w When engine is running, abnormal noise is heard from around cylinder head w Hign idle speed of engine is high Q High idle speed is normal, but speed suddenly drops when load is applied Q w Q Q Engine does not pick up smoothly and combustion is irregular w w Q Q w There is hunting from engine (rotation is irregular) Q Q Q Q Q Blow-by gas is excessive w w Troubleshooting Check air cleaner directly q Check air intake piping directly q When boost pressure is measured, it is found to be low q q q When compression pressure is measured, it is found to be low q q Check valve clearance directly q Check fuel piping q Check fuel filter, strainer directly q Check spill port check valve directly q Carry out troubleshooting for code display “Supply pump pressure no signal (*1)“ q Engine speed does not change when operation of certain cylinders is stopped in reduced cylinder mode q q Check mounting of boost pressure sensor directly q Carry out troubleshooting for code display “Abnormality in boost pressure sensor (*2)“ q Action Clean Correct Replace Replace Adjust Replace Clean Correct Replace Replace Replace Replace Correct Replace Replace