Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — S-7 EXHAUST SMOKE IS BLACK (IMCOMPLETE COMBUSTION)

SEN00595-00 40 Troubleshooting S-7 Exhaust smoke is black (imcomplete combustion) 1 *1:Failure code of code display [CA559] and [CA2249] *2:Failure code of code display [CA114] and [CA145] 14 D65EX, PX, WX-15E0 General causes why exhaust smoke is black • Insufficient intake of air • Abnormal fuel injection condition • Improper selection of fuel • Engine overheating:

See “S-14 Coolant temperature becomes too high (overheating)“ • Controller controlled by derate mode (The injection amount (output) is limited because a failure has occurred in the electrical system.) Cause Clogged air cleaner element Seized turbocharger, interference Defective contact of valve, valve seat Improper valve clearance Leakage of air between turbocharger and cylinder head Crushed, clogged muffler Worn piston ring, cylinder liner Stuck, seized fuel supply pump plunger Clogged, seized fuel injector Worn fuel injector Defective fuel injection timing Defective fuel injection pressure Defective coolant temperature sensor, defective wiring harness Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E E E E Color of exhaust gas Suddenly became black w w Q Q Q Gradually became black w Q Q Blue under light load w Non-specified fuel is being used Q Q Engine oil must be added more frequently w Power was lost Suddenly w Q Q Q Gradually Q Q Q Q Dust indicator lamp is red (when indicator is installed) w Muffler is crushed w Leakage of air betweeen turbocharger and cylinder head, loose clamp w Operates in low-temperature mode even at normal temperatures Q Q Q When exhaust manifold is toutched immediately after starting engine, temperature of some cyl- inders is low Q w When engine is running, noise of interference is heard from around turbocharger w When engine is running, abnormal noise is heard from around cylinder head w Rotation speed of torque converter stall and pump relief is high (excessive injection of fuel) Q Exhaust noise is abnormal Q w Q Engine does not pick up smoothly and combustion is irregular Q Q Q Q Q w Blow-by gas is excessive w When hose from injector to spill collection portion is disconnected, spill flow is found to be abnormally high w Troubleshooting Check air cleaner directly q When turbocharger is rotated by hand, it is found to be heavy q When compression pressure is measured, it is found to be low q q Check valve clearance directly q When muffler is removed, exhaust color returns to normal q Carry out troubleshooting for code display “Supply pump pressure no signal (*1)“ q q Engine speed does not change when operation of certain cylinders is stopped in reduced cylin- der mode q Carry out troubleshooting for code display “Abnormality in coolant temperature sensor (*2)“ q Confirm with monitoring function of INSITE or on the machine q q Action Clean Replace Replace Adjust Correct Replace Replace Replace Replace Replace Adjust Replace Replace