SEN00945-00 50 Disassembly and assembly Engine and cooling system, Part 1 1 Removal and installation of fuel supply pump assembly 1 4. Remove bracket (4). 5. Disconnect hose (5). [*1] a Make a mark (M) at the tube end of each hose to show the original position of the hose. Special tools Removal k Disconnect the cable from the negative (–) terminal of the battery. a Since the hose band (MIKALOR clamp) cannot be reused, use new one. See [*1]. a The fuel tube connector is new type (To discon- nect it, press its lock from both sides and pull it). See step 22. 6. Loosen adjustment bolt (6) of the air condi- tioner compressor.
k The internal parts of the adapters may be damaged when fuel tubes (23), (24) and (25) are removed. Accordingly, replace the adapters with new ones. 7. Loosen the mounting bolt of air conditioner compressor bracket (7). 8. Remove belt (8). [*2] 1. Close the fuel supply valve from under the fuel tank. 9. Disconnect air conditioner compressor hose clamp (9). 2. Open engine left side cover (1). 10. Disconnect wiring harness clamps (10) and (11). 3. Remove covers (2) and (3). 11. Disconnect connector clip (12). 12. Disconnect connector A/C (13). 13. Disconnect ground wire (14). 14. Remove the air conditioner compressor and bracket (7) together.
a Do not disconnect the air conditioner com- pressor hose but place it on the track shoe. 2 D65EX, PX, WX-15E0 Symbol Part number Part name Necessity Q’ty N/R Sketch A 1 795-799-1131 Gear t 1 2 795-799-1390 Remover t 1