50 Disassembly and assembly SEN00945-00 15. Remove high-pressure pipe clamp (15). [*3] 24. Disconnect receiver drier and bracket assem- bly (26). 16. Remove right and left bellows (16). [*3] 17. Remove high-pressure pipe (17). [*3] 25. Remove cap (27). 26. Install gear A1 (See the Special tools table) to rotate the crankshaft. a See Testing and adjusting, “Testing and adjusting valve clearance”. 18. Disconnect lubrication tube (18). [*4] 19. Disconnect clamp (19). 20. Disconnect brackets (20) and (21). [*5] 21. Disconnect connector (22) from the back of bracket (21). 22. Disconnect fuel tube (23).
[*6] a While pressing locks (L) at the front and rear of fuel tube (23), pull it down to dis- connect. 27. Twist off cap (28). a Use a filter wrench etc. to remove the cap. 28. Rotate the crankshaft and set stamp (M) of drive bear (GY) to the top dead center. a Use a mirror. a See Testing and adjusting, “Testing and adjusting valve clearance”. 29. Remove nut (29) and washer (30) from shaft (SH) of the fuel supply pump. a Take care not to drop the nut and washer into the case. 23. Disconnect fuel tubes (24) and (25) similarly to fuel tube (23). [*6] D65EX, PX, WX-15E0 3