SEN00945-00 50 Disassembly and assembly 30. Tighten tool A2 evenly to disconnect shaft (SH) of the fuel supply pump from drive gear (GY). Installation q Install the fuel supply pump assembly accord- ing to the following procedure. 1. Install fuel supply pump assembly (33), match- ing projection (P) of its shaft SH to groove (G) of gear (GY). 31. Remove bracket (31). 32. Remove 4 nuts (32) and fuel supply pump assembly (33). 2. Install bracket (31) to fuel supply pump assem- bly (33) and tighten 4 nuts (32). 2 Mounting nut: Adhesive (LT-2) 3 Mounting nut and bracket mounting bolt: 43 ± 6 Nm {4.4 ± 0.6 kgm} 3. Set washer (30) and tighten nut (29).
a When installing the nut and washer, take care not to drop them into the case. 3 Nut: 178 ± 13 Nm {18.2 ± 1.3 kgm} q Carry out the following installation in the reverse order to removal. 4 D65EX, PX, WX-15E0