50 Disassembly and assembly SEN00945-00 72. Twist off cap (83). a Use a filter wrench etc. to remove the cap. 80. Loosen locknut (90) and then loosen adjust- ment screw (91) 2 – 3 turns. a This work must be performed so that an excessive force will not be applied to the push rod when the rocker arm is installed. 73. Rotate the crankshaft and set stamp (M) of drive bear (GY) to the top dead center. a Use a mirror. a See Testing and adjusting, “Testing and adjusting valve clearance”. 81. Remove mounting bolt (92) and rocker arm and crosshead assembly (93). a Record the position and direction (shapes of holes "a" and "b") of each crosshead.
(When reinstall the crosshead, set it in the same direction.) 74. Disconnect clamp (84). 75. Disconnect oil hose (85). 76. Remove cover (86). 77. Remove air intake cover (87). [*13] 78. Remove cylinder head cover (88). [*14] a Referring to Testing and adjusting, "Test- ing and adjusting valve clearance", check to see if the No. 1 cylinder is at the top or the No. 6 cylinder is at the top. 82. Remove retainer (95) and inlet connector (96). a Before removing retainer (95), remove all dirt from it and its periphery. a Tool A4 (remover) is set for removal of inlet connector (96). (See Special tools table.) 79. Remove wiring harness nut (89) from the injec- tor.
D65EX, PX, WX-15E0 11 Color of wiring harness Cylinder No. Yellow, Orange (Exchangeable) 1, 3, 5 Red, Brown (Exchangeable) 2, 4, 6