Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — REMOVAL AND INSTALLATION OF FUEL INJECTOR ASSEMBLY

50 Disassembly and assembly SEN00945-00 12. Remove wiring harness nut (8) from the injec- tor. 15. Remove retainer (14) and inlet connector (15). a Before removing retainer (14), remove all dirt from it and its periphery. a Tool A4 (remover) is set for removal of inlet connector (15). (See Special tools table.) 13. Loosen locknut (9) and then loosen adjustment screw (10) 2 – 3 turns. a This work must be performed so that an excessive force will not be applied to the push rod when the rocker arm is installed. 14. Remove mounting bolt (11) and rocker arm and crosshead assembly (12). a Record the position and direction (shapes of holes "a" and "b") of each crosshead.

(When reinstall the crosshead, set it in the same direction.) 16. Remove 2 mounting bolts (13) of the injector assembly. 17. Using tool A3 , remove injector assembly (16). a Take care that dirt and foreign matter will not enter the mounting part of the fuel injector assembly. Installation 1. Referring to “Removal and installation of cylin- der head assembly”, step 8 – 17, install the fol- lowing parts. q Fuel injector assembly q Rocker arm and crosshead assembly q Carry out the following installation in the reverse order to removal. [*1] Referring to “Removal and installation of cylinder head assembly”, step 8, install the following parts.

q High-pressure pipe q Common rail D65EX, PX, WX-15E0 19