Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — REMOVAL AND INSTALLATION OF FUEL INJECTOR ASSEMBLY

SEN00945-00 50 Disassembly and assembly Removal and installation of fuel injector assembly 1 6. Twist off cap (3). a Use a filter wrench etc. to remove the cap. Special tools 7. Rotate the crankshaft and set stamp (M) of drive bear (GY) to the top dead center. a Use a mirror. a See Testing and adjusting, "Testing and adjusting valve clearance." Removal k Disconnect the cable from the negative (–) terminal of the battery. 1. Remove the engine hood assembly. For details, see “Removal of engine hood assembly”. 2. Referring to “Removal of cylinder head assem- bly”, steps 3 – 30 and 42 – 52, remove the fol- lowing parts. [*1] 8. Disconnect clamp (4). q Air cleaner and air cleaner bracket 9.

Disconnect oil hose (5). q Muffler q Filter and filter bracket 10. Remove cover (6). q Air intake connector 11. Remove cylinder head cover (7). a Referring to Testing and adjusting, “Test- ing and adjusting valve clearance”, check to see if the No. 1 cylinder is at the top or the No. 6 cylinder is at the top. q High-pressure pipe 3. Disconnect receiver drier and bracket assem- bly (1). 4. Remove cap (2). 5. Install gear A1 (See the Special tools table) to rotate the crankshaft. a See Testing and adjusting, “Testing and adjusting valve clearance“.

18 D65EX, PX, WX-15E0 Symbol Part number Part name Necessity Q’ty N/R Sketch A 1 795-799-1131 Gear t 1 3 795-799-6700 Puller t 1 4 795-799-8150 Remover q 1