Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — REMOVAL AND INSTALLATION OF CYLINDER HEAD ASSEMBLY

50 Disassembly and assembly SEN00945-00 9. Apply caulking material "e" (hatched part) to nut (95) of inlet connector (96) and cylinder head. 3 Mounting bolt of turbocharger lubrication tube (71): 24 ± 4 Nm {2.4 ± 0.4 kgm} 2 Caulking material: GE TOSHIBA SILICONES TOSSEAL 381 [*12] q Exhaust manifold and turbocharger 3 Tightening order of mounting bolts: 1) Tighten all the bolts to 24 ± 4 Nm {2.4 ± 0.4 kgm} in the order of [1] – [12] in the figure. 2) Tighten only bolts [1] – [4] to 24 ± 4 Nm {2.4 ± 0.4 kgm} in the order of [1] – [4] in the figure. 3) Tighten all the bolts to 43 ± 6 Nm {4.4 ± 0.6 kgm} in the order of [1] – [12] in the figure.

4) Tighten only bolts [1] – [4] to 43 ± 6 Nm {4.4 ± 0.6 kgm} in the order of [1] – [4] in the figure. 10. Install 12 bellows (51). 11. Install right and left bellows (40). a Install each bellows with the slits out and down. a The bellows are installed so that fuel will not spout over the hot parts of the engine and catch fire when it leaks for some rea- son. [*13] q Air intake manifold cover Fit the gasket and install the air intake manifold cover. 2 Both sides of gasket: Gasket sealant (LG-7) 3 Mounting bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} [*14] 3 Cylinder head cover mounting bolt:

12 ± 2 Nm {1.2 ± 0.2 kgm} [*9] q Fuel hose (61) k The internal parts of the adapter may be damaged when fuel tube (61) is removed. Accordingly, replace the adapter with new one. q Refilling with coolant Add coolant through the coolant filler to the specified level. Run the engine to circulate the coolant through the system. Then, check the coolant level again. [*10] 3 Clamp of radiator hose (66): 8.8 ± 0.5 Nm {0.9 ± 0.05 kgm} 5 Coolant: Approx. 39 l [*11] 3 Mounting nut of turbocharger lubrication hose (70): 35 ± 5 Nm {3.6 ± 0.5 kgm} D65EX, PX, WX-15E0 17