SEN00945-00 50 Disassembly and assembly a Measure the facial runout and radial runout of the flywheel and flywheel housing. (Check with dial gauge [4].) q Facial runout: Max. 0.20 mm q Radial runout: Max. 0.20 mm q Measuring radial runout 1) Install dial gauge [4] to the end of the crankshaft. 2) Set the probe of the dial gauge per- pendicular to the socket of the fly- wheel housing. 3) Set the dial gauge to "0", rotate the crankshaft 1 turn, and measure the difference between the lowest and highest values. a After the flywheel is rotated 1 turn, check that the dial gauge indicates the value at the start of rotation.
q Measuring facial runout 1) Similarly to measurement of the radial runout, set the probe of the dial gauge perpendicular to end face of the flywheel. a When measuring, bring the crankshaft to the front or rear side so that an error will not be caused by the end play. 2) Set the dial gauge to "0", rotate the crankshaft 1 turn, and measure the difference between the lowest and highest values. 26 D65EX, PX, WX-15E0