50 Disassembly and assembly SEN00945-00 9. Install alignment tool (A) again and check that rear seal (7) is inserted to a proper depth. a The level difference between the bottoms of the cylinder block and rear cover (6) must be 0.00 ± 0.10 mm. a Keep alignment tool (A) installed. 10. Remove guide pin [2] and tighten the 8 rear cover mounting bolts in the following order. 3 Rear cover mounting bolt: 12.7 ± 2.0 Nm {1.3 ± 0.2 kgm} a The projection of rear cover gasket (G) from the bottom of the cylinder block must not exceed 0.25 mm. q Carry out the following installation in the reverse order to removal. [*1] a Fix the flywheel to the flywheel housing with ring wrench [3].
a Tighten the mounting bolts in the order shown in the following figure. 3 Flywheel mounting bolt: 137 ± 7 Nm {14.0 ± 0.7 kgm} 11. Remove alignment tool (A). 12. Install flywheel housing. 2 String 1 – 3 mm in diameter around mounting bolt hole on cylinder block face side: Gasket sealant (LG-6) a Tighten the mounting bolts in the order shown in the following figure. 3 Flywheel housing mounting bolt: 77 ± 12 Nm {7.9 ± 1.2 kgm} D65EX, PX, WX-15E0 25