SEN00945-00 50 Disassembly and assembly Installation 4. Install engine rear seal (7) to rear cover (6). 1. Clean, degrease, and dry the gasket faces against the rear cover and cylinder block. 2. Clean, degrease, and dry the seal lip face (periphery of the crankshaft). 5. Using alignment tool (A) attached to the engine rear seal, push rear seal (7) into rear cover (6) to a proper depth. 3. Apply neutral detergent to the periphery of the engine rear seal. a Since plastic part (P) on the inside of the engine rear seal is a pilot (guide tool) for installation of the crankshaft, do not remove it from the engine rear seal. 6. Remove alignment tool (A). 7.
Apply pilot (P) to the crankshaft and push it and rear cover (6) into the crankshaft with the hands. a Do not forget gasket (G). a Use guide pin [2]. 8. Remove pilot (P). 24 D65EX, PX, WX-15E0