50 Disassembly and assembly SEN00945-00 Removal and installation of engine rear seal 1 Special tools Removal k Disconnect the cable from the negative (–) terminal of the battery. 8. Remove rear cover (6). 9. Remove rear seal (7) from rear cover (6). a Take care not to scratch the seal fitting face of the flywheel housing and seal con- tact face of the crankshaft. 1. Remove the engine assembly. For details, see “Removal and installation of engine assembly”. 2. Place engine assembly (1) on block [1]. a Repair stand and adapter A7 are set (See Special tools table). 3. Remove the damper assembly. For details, see “Removal and installation of damper assembly”. 4.
Remove the mounting bolts, set guide bolts, and lift off flywheel (2). [*1] 4 Flywheel assembly: 45 kg a If engine rear seal (7) is stuck to the crankshaft and cannot be removed, make holes (about 3 mm in diameter) on its right and left sides with a drill. Then, using seal puller A5 , remove the seal with impacts of slide hammer (SH). 5. Disconnect wiring harness (3) from flywheel housing (5). 6. Set the block under the flywheel housing side of engine assembly (1). 7. Sling flywheel housing (5), remove mounting bolts (4), and lift off flywheel housing (5). 4 Flywheel housing (5):
70 kg D65EX, PX, WX-15E0 23 Symbol Part number Part name Necessity Q’ty N/R Sketch A 5 795-931-1100 Seal puller q 1 7 795-799-1150 Repair stand q 1 795-799-2280 Adapter q 1